Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador página 20

TROUBLESHOOTING
SYMPTOM
Power/Exhaust Stage of
Operation
1. Tool operates properly, but
fasteners do not drive fully.
2. Tool operates, but no fastener is
driven.
3. Tool operates erratically or appears
to be losing power.
Returning/Purging Stage of
Operation
1. Tool operated and drove fastener,
but piston did not return to up
position.
2. Combustion Chamber does not
drop after tool cycles.
POSSIBLE PROBLEMS
1a. Battery is discharged.
1b. Fuel Cell is low.
1c. There may be loss of seal in
combustion chamber.
2a. Fastener strip may be binding.
2b. Follower not properly engaged
behind fastener.
2c. Jammed fastener.
3a. Fuel Cell is low.
3b. Spark Plug wire is loose.
3c. Filter element is dirty, causing tool to
overheat.
3d. Tool Sleeve or O-Rings are dirty.
1a. Built-up dirt and debris on Piston or
in Nose bore.
1b. Mushrooming of Piston Tip.
1c. Exhaust ports on the Sleeve are dirty
or clogged.
1d. Tool (Sleeve) or O-Rings are dirty.
1e. Piston rings require replacement.
2. Contact Arm is bent, or tool is dirty.
20
TRAK-IT TOOL MODEL C3, C3 ST
SERVICE
1a. Charge Battery.
1b. Check Fuel Cell according to Operating Manual and
replace as required.
1c. Press Contact Arm against work piece for one
minute. Pull trigger. If fastener does not drive, there
is a leak that requires service.
2a. Use only fasteners meeting Powers Fasteners
specifications.
2b. Locate follower behind fastener strip and engage strip
according to instructions in Operating Manual.
2c. Clear jam according to Operating Manual.
3a. Check Fuel Cell according to Operating Manual.
3b. Contact Powers Customer Service Representative for
Service.
3c. Remove Filter element and clean according to
Operating Manual. Use compressed air to remove
stubborn debris.
3d. Return to Powers Fasteners Customer Service
Representative for Service.
1a. Return to Powers Fasteners Customer Service
Representative for Service.
1b. Return to Powers Fasteners Customer Service
Representative for Service.
1c. Return to Powers Fasteners Customer Service
Representative for Service.
1d. Return to Powers Fasteners Customer Service
Representative for Service.
1e. Return to Powers Fasteners Customer Service
Representative for Service.
2. Clean tool or replace Contact Arm as required.
20