Safety Instructions - Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador

7

SAFETY INSTRUCTIONS

The following safety instructions have been included in this manual to provide you with
basic information necessary for safe operation of the Trak-It Tool. DO NOT ATTEMPT TO
OPERATE THIS TOOL UNTIL YOU HAVE READ AND UNDERSTOOD ALL SAFETY
PRECAUTIONS AND MANUAL INSTRUCTIONS.
Failure to follow all safety precautions and manual instructions can result in blindness,
severe personal injury, damage to personal property, and damage to the tool.
In addition to these instructions, additional training may be necessary, depending upon
the type of fastening you wish to do. Contact your Powers Fasteners customer service
representative for additional information.
DANGER
THE TRAK-IT TOOL IS AN INTERNAL COMBUSTION DEVICE. IT PRODUCES HOT
EXHAUST GASES THAT MAY IGNITE FLAMMABLE MATERIALS. THIS TOOL MUST NOT
BE USED IN A COMBUSTIBLE ENVIRONMENT OR IN THE PRESENCE OF COMBUSTIBLE
MATERIALS, SUCH AS FLAMMABLE CHEMICALS, ADHESIVES, GASOLINE, OR
SOLVENTS. CARE MUST BE TAKEN TO PREVENT A TOOL CONTAINING A FUEL CELL
FROM BEING EXPOSED TO TEMPERATURES IN EXCESS OF 120 ˚F (49 ˚C), SINCE THE
FUEL CELL COULD BURST RELEASING FLAMMABLE GAS.
THIS TOOL MUST BE OPERATED ONLY IN A WELL-VENTILATED ENVIRONMENT,
BECAUSE THE TOOL EXHAUSTS CARBON MONOXIDE SIMILAR TO A CHAINSAW OR
LAWN MOWER. EXPOSURE TO CARBON MONOXIDE MAY CAUSE DIZZINESS NAUSEA,
OR UNCONSCIOUSNESS.
THE TRAK-IT TOOL, THE FUEL CELLS, AND THE BATTERY CELL AND ITS CHARGER
SHOULD ALWAYS BE KEPT OUT OF THE REACH OF CHILDREN.
1. READ THIS MANUAL FROM COVER TO COVER. Always refer to this manual for
information about the safe operation and servicing of the Trak-It tool. If any portion
seems unclear, or you have any questions, contact your Powers Fasteners customer
service representative immediately.
2. WEAR EYE AND HEARING PROTECTION. Always wear hearing and eye protection
devices when you are operating the Trak-It tool or working in the vicinity of this tool.
Also, your eye protection must meet the requirement of ANSI STANDARD Z 87. 1 (Counsil
directive 89-686-EEC dated 21 Dec, 1989).
3. NEVER ASSUME THE TOOL IS EMPTY. Every time you pick up the Trak-It tool, check
the Magazine for fasteners. Never point the tool at anyone or yourself, even if you are
absolutely sure there are no fasteners in the tool. The fastener you did not see is the
fastener that can injure you or someone else.
TRAK-IT TOOL MODEL C3, C3 ST
7