Presentation - Hergom CRAFTSBURY Instrucciones Para Instalación, Uso Y Mantenimiento

1 - INTRODUCTION
IMPORTANT! All local regulations, including those
that refer to national or European regulations,
must be applied when installing this device.
The way the Craftsbury Stove is installed will
decisively affect safety issues and its correct
operation.
It is important to install the fireplace correctly. For
the correct installation of the Craftsbury stove and
chimney, we recommend the installation be
performed by a professional.
The E-30 Stove provides heat by radiation; directly
heating walls, ceilings...

2 - PRESENTATION

The Craftsbury wood burning heater has the
following main characteristics:
• It is constructed in cast iron, with assembled
parts, sealed and screwed together.
• A hearth that allows to burn wood logs of up to
45 cms. long.
• Primary air regulation valve.
• Indirected system of primary air supply, that
descends down the inside plan of the glass (self
cleaning) towards the bottom of the hearth.
Supplied, as well, with a primary air hole
located in a nozzle in the space under the door
to favour the lighting.
• Secondary air with self regulation that increases
the heater's performance and reduces the
unburnt gas emission to the atmosphere.
• Glass self-cleaning.
• Hinged front door with glass.
• Air-tight ash pan door.
• A top practical for cleaning and maintenance.
• Optional horizontal or vertical smoke exit Ø150
mm. (6")
• Double grill
• It lets of its heat by radiation, directly heating
the walls, roofs, etc. .
• Fully factory assembled, except for chimney
collar piece.
3 - INSTALLATION OF SMOKE COLLAR
The chimney collar can be found wrapped up inside
the stove.
Unpack and loosen the nuts and washers.
Place the collar in its place and fix to the stove with
the screws.
Make sure the sealing ring has been properly
installed.
13
FIG. 1