Pool Clamp Removal - Jandy Pro Serie Manual De Instalación Y Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Neutral
Line
GFCI
Ground
Figure 4.
Wiring the Jandy Pro Series White LED
Light to a Time Clock
Neutral
White
Line
Black
GFCI
Ground
Ground
Figure 5.
Wiring the Jandy Pro Series White LED
Light to a Switch
Section 7. Replacing LED Board
and Driver (PCB)
WARNING
Always disconnect power to the light at the circuit
breaker before servicing the light. Failure to do so
could result in death or serious injury to installer,
serviceman, pool or spa users or others due to
electrical shock.
1.
Turn off the main electrical switch or circuit
breaker, as well as the switch, which operates the
underwater light.
2.
Be sure to have the following items:
• A new lens gasket.
• A light driver board. See Table 2 for specification.
Jandy
Pro Series, White LED Lights
®
120V
LED
Light
Clock
Motor
1
A
2
Black
White
JUNCTION
BOX
Green
Ground
120V
LED
Light
SWITCH
Black
White
JUNCTION
BOX
Green
|
Installation Manual
WARNING
Replace light driver with the same type. Failure to
replace the light driver with the same type will damage
the light assembly and may cause an electrical hazard
resulting in death or serious injury to pool or spa users,
installers, or others due to electrical shock, and may
also cause damage to property. Be sure the power is
switched OFF before removing or installing PCB. Allow
PCB to cool before replacing.
3.
To remove the light assembly, unscrew the special
pilot screw at the top of the face ring, remove
light assembly from niche and gently place
assembly on the deck. It is not necessary to drain
down the pool. See Figure 6.
Table 2.
Light Specifications
Jandy Pro
Fixture
Series Model
Voltage
White LED
12 VAC
Large Light
White LED
120 VAC
Large Light
White LED
12 VAC
Large Light
White LED
120 VAC
Large Light
White LED
120 VAC
Small Light
White LED
12 VAC
Small Light
WARNING
Be sure to keep the special pilot screw from this
underwater light. This screw mounts and electrically
grounds the housing securely to the mounting ring
and wet niche. Failure to use the screw provided could
create an electrical hazard, which could result in death
or serious injury to pool or spa users, installers or
others due to electrical shock.
7.1

Pool Clamp Removal.

1.
Loosen the Phillips head screws (six (6) for small
light, eight (8) for large light) to allow the bottom
clamp to be removed from the face ring assembly.
Do not remove the screws or the retaining rings.
The retaining rings prevent the screws from
falling free from the bottom clamp and also aid in
ease of assembly.
Page 9
ENGLISH
Watts
Light Driver (PCB)
Part Number
65W
R0802600
65W
R0802700
42W
R0802800
42W
R0802900
R0803200
R0803300

Publicidad

Tabla de contenido
loading

Tabla de contenido