General Safety Instructions - OMG AccuTrac Manual Del Propietário

When using electric tools, safety precautions should always be followed to reduce the risk of fire, electric shock, and personal
injury. Failure to follow these instructions can result in severe personal injury.
General Safety Considerations
1. Before using the tool, become familiar with all of the oper-
ating instructions.
2. Don't use the tool for purposes not intended.
3. Failure to wear safety glasses with side shields can result in
severe eye injury or blindness. Always wear safety glasses
with side shields that conform to ANSI Standard Z87.1.
4. Keep the work area clean and well lit. Dark, cluttered work
areas and benches invite injuries.
5. Dress properly! Never operate the tool while wearing loose
clothing or jewelry. They can be caught in moving parts.
6. Maintain proper footing and balance at all times:
• Don't use the tool in an awkward position.
• Don't overreach.
7. Stay alert! Watch what you are doing! Use common
sense! Do not operate tool when you are tired!
Safety Procedures For Electric Tools
1. Guard against electric shock.
2. Consider work area environment:
• Never operate tool in damp or wet locations.
• Prevent body contact with grounded surfaces, such
as pipes.
• Use only extension cords intended for outdoor use and
so marked.
• Wear rubber gloves and non-skid footwear when work-
ing outdoors.
• Don't expose power tools to rain.
• Never operate tool in the presence of flammable liquids
or gases.
W A R N I N G
Read All Instructions
SAVE THESE INSTRUCTIONS
OMG ROOFING PRODUCTS
3. Never allow visitors to contact the tool or extension cords.
All visitors should be kept away from the work area.
4. Don't abuse the tool:
• Keep handle dry, clean and free from oil and grease.
• Never carry the tool by the cord or yank it to disconnect
from the receptacle.
• Always keep the cord from heat, oil and sharp edges.
• Always store an idle tool in a dry, high or locked-
up place.
• Always disconnect the tool when it's not in use or
before servicing.
• To avoid unintentional starting, never carry a plugged-in
tool with finger on the switch. Be sure the switch is OFF
when plugging in.
5. Maintain the tool with care. Check damaged parts. Before
further use of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, break-
age of parts, mounting and any other conditions that may
affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in
this instruction manual. Have inoperative switches replaced
by an authorized service center. Do not use the tool if the
switch does not turn the tool ON and OFF.
• When servicing double insulated tool, use identical
replacement parts.
• Keep the tool clean for better and safer performance.
• Inspect the tool cord periodically and, if damaged, have
it repaired by an authorized service facility.
• Inspect the extension cord periodically and replace it if
it's damaged.
800 . 633 . 3800
WWW.OLYFAST.COM
1