Troubleshooting - OMG AccuTrac Manual Del Propietário

Problem: Plates Not Feeding Smoothly or Completely
POTENTIAL CAUSE
Plates have been inserted upside down
Dirty ejector blade and/or guides
Gate is sticking
Ejector blade screws are loose
Ejector blade insert screws are loose
Ejector blade insert undercut is clogged
Plate retaining spring is not
completely seated
Nosepiece is bent
Plate stop screws are loose
Plate rod is not completely seated
Problem: Missing or Skipped Plates
POTENTIAL CAUSE
Plate is bent or previously used
Ejector blade insert disc(s) is/are missing
Incorrect plates are being used
Ejector blade insert disc undercuts are
dirty/clogged
Troubleshooting Problems
REMEDY
Remove plates from plate hold and reinstall so the notch in the plate fits the
extrusion in the plate hold.
Clean the ejector blade and/or guides with degreaser.
Clean the gate with a degreaser.
Remove the screws, clean the screws and threaded holes.
Apply Loctite 242 and reinstall screws.
Remove the screws, clean the screws and threaded holes.
Apply Loctite 242 and reinstall screws.
Clean out the undercut.
Turn the handle clockwise and gently pull upward.
Call 1 . 800 . 633 . 3800 for service. Do not attempt to remove nosepiece.
Remove the screws, clean the screws and threaded holes. Apply Loctite 242
and reinstall screws.
Turn handle clockwise and gently pull upward.
REMEDY
Disconnect upper links from the feed tube and slide ejector blade forward.
Remove suspect plate(s). Reconnect upper links and continue.
Replace missing insert.
Use only OMG Roofing Products AccuTrac plates.
Clean out undercuts.
OMG ROOFING PRODUCTS
800 . 633 . 3800
WWW.OLYFAST.COM
7