Speck pumps Badu Jet super-sport II Manual De Instalación página 11

Jet Housing Installation - New Concrete or Gunite Construction - continued
Slide the inner wall formwork over the studs in the
n
jet housing through the pre-drilled holes. Secure the
formwork to the jet housing with four (4) M8 washers
(part #32) and four (4) M8 nuts (part #33).
5. For gunite pools:
Mount the gunite cover to the front of the jet housing
n
using the four (4) M8 x 80mm studs (part #31), four
(4) M8 washers (part #32) and four (4) M8 nuts (part
#33). Tape the edge of the gunite cover around the
entire jet housing to keep gunite out of threaded
inserts and out of the jet housing.
Place the jet housing between the steel rebar. Jet
n
housing location is very important (See Figure 6).
6. Pour concrete or apply gunite:
Front edge of the jet housing should finish even with
n
the inside pool wall. Make sure a V shaped groove is
scraped out around the housing approximately 1.5"
deep to allow marcite to seal against the housing.
Recheck the location of the jet housing when concrete
n
or gunite is being applied. Make sure the jet housing
remains properly aligned and level.
To avoid stress on the housing, the jet housing and
n
2 to 3 inches of plumbing/conduit stub out may be
encased in gunite or concrete.
Store all parts not being used now in original box. Store
n
in a safe place until needed.
7. Once the concrete or gunite is fully cured and pool wall is
completed, remove the M8 nuts and washers, gunite cover,
and M8 studs. Be sure that the front edge of the jet housing
is flush with the pool wall.
CAUTION: During plastering, the gunite cover, studs,
washers, and nuts should remain installed on the jet housing.
8. Install the clamping ring (part# 28) based on your pool
construction:
Gunite wall (no tile or liner):
n
Align the clamping ring (part# 28) then use the twelve
(12) M8 x 30 clamping ring screws (part# 52) to attach
the clamping ring to the jet housing.
1)
14.0"
1)
Figure 5
Installation Template for Concrete or Gunite Pools
Round Sealing Cord
Discharge connection UP!
Suction connection
Formwork
Figure 6
Installation formwork for Concrete or Gunite Pools
WATER LEVEL
1)
1)
13.3"
0.3"
1) Fastening to the formwork (4x)
WATER LEVEL
Gunite Cover
Gunite Cover
Stud & Nut
Gasket with Knobs
Formwork
~9.4
11