Final Assembly - Speck pumps Badu Jet super-sport II Manual De Instalación

Final Assembly

1. Insert the o-ring (part# 62) in the jet housing as shown
in Figure 14.
2. Start the ten (10) nozzle housing tapping screws (part#
61) into the pre-assembled nozzle housing (part# 102.1).
Place the nozzle housing at the main jet housing.
3. Feed both lengths of air tubing (part# 47) through the
protective conduit as shown in Figure 14. Allow enough air
tubing to reach the control box and air buttons. Excess can
be trimmed upon installation. Mark each end with a marker.
(P = Pump & L = Light.)
4. Fasten the internal air regulator hose (part# 4) to the hose
nipple inside the jet housing using the hose clamp (part #9).
5. Route the air tubing through the air button openings of
the nozzle housing.
NOTE: Light ON/OFF button is on the left and the pump ON/
OFF button is on the right.
6. Align the complete nozzle housing to the main jet housing
and fasten the ten (10) pre-assembled tapping screws.
All screws should be HAND TIGHT. DO NOT use drills or
pneumatic tools. DO NOT over tighten!
7. Place the rectangular cover (part# 93) against the clamping ring (part #28) and fasten with four (4) 8.4mm washers
(part# 94) and four (4) M8 x 20 machine screws (part# 95) and cover the openings with the rectangular covers (part# 96).
All screws should be HAND TIGHT. DO NOT use drills or pneumatic tools. DO NOT over tighten! Make sure the UP label is in
the correct position.
WARNING: DO NOT use or operate the BaduJet super-sport II if the anti-entrapment cover is missing, broken, or loose.
8. Guide the air tubing through the two (2) bottom openings of the light cover (part# 110).
NOTE: Light ON/OFF button is on the left and the pump ON/OFF button is on the right. Align the light cover with the nozzle
housing and secure with four (4) light cover tapping screws (part# 112). (See Figure 15)
9. Slide one (1) o-ring (part# 37) onto each air button. Fasten each length of air tubing to the corresponding buttons using
the hose clamps (part# 48). Insert the two (2) air buttons through the light cover and into the nozzle housing and lock them
by turning them clockwise until they 'click' into place.
10. Mount the volume control knob (part #21.1) and air regulator knob (part #111) by means of a rubber mallet and a
protective cloth. (See Figure 16)
16
47
20
101
14
1
7
28
A
Figure 14
9
A
108
4
102.1
A
61