Clarion NAX963HD Guia De Instalacion página 9

0426-UK.book Page 10 Wednesday, April 26, 2006 10:52 PM
Wire Connection
Notes on wire connection
When connecting the plugs and sleeves, be sure to insert the plug until it locks securely. After
completing connections, fasten the cords using cord clamps and tapes.
Female
Sleeve
If the male knob is in the shape shown at A,
cut the female sleeve about 5 mm.
Example of connecting reverse gear or handbrake signal lead
Connect each signal lead using the supplied electro-taps.
From this unit
1. Place the lead from this unit at the stopper, and fold it back in the direction of the arrow.
2. Pass the vehicle signal lead through, and fold it back in the direction of the arrow.
Vehicle and main unit signal lead
Vehicle and main unit signal lead
Example of relay usage
Use a special installation kit (relay cord kit), sold separately, prepared specifically for your model. For
applicable models, consult the dealer where you purchased this unit.
Note:
When connecting the main power supply cord (yellow) of the main unit, connect it to a spare terminal of this unit.
(Yellow)
Ground cord from this unit
10
NAX963HD
Cut 5 mm.
Male
Coupler connected to other equipment
3 Electro-tap
Power supply lead from this unit
Stopper
Power supply lead from this unit
Vehicle coupler
(Yellow)
To main unit
Relay cord (Sold separately)
Conforms to EIAJ standard (CP2501)
Tighten with the vehicle side screw and fasten
securely to the vehicle metal part.
tape
Clamp