Thermistor - LG PQRCHCA0Q Manual De Instrucciones

INSTALLATION INSTRUCTION
12
E.S.P
This is the functional that decides the strenth
of the wind for each wind level and because
this function is to make the installation easier.
- If you set ESP incorrectly, the air conditional
may malfunktion.
- This setting must be carried out by a certifi-
cated-thecnition.
1
Press button and
neouslly for more than 3 seconds.
2
Setup function code '03' pressing by
button.
3
Select ESP fan step and ESP value.
ESP Value
* ESP value range : 0~255
4
Press button to save.
5
Press button and
neouslly for more than 3 seconds After the
setting has been completed.
!
NOTE
• When setting ESP value on the product
without very weak wind or power wind
function, it may not work.
• Please be careful not to change the ESP
value for each fan step.
• It does not work to setup ESP value for
very low/power step for some product.
• ESP value is available for specific range
belongs to the product.
button Simulta-
ESP step
Function Code
Value
ESP step
button Simulta-

Thermistor

This is the function to select the temprature
sensor to judge the room temperature.
1
Press button and
neouslly for more than 3 seconds.
2
Setup function code '04' pressing by
button.
3
Set Thermistor value by pressing button by
pressing temperature button.
(01: Remote Controller, 02: Indoor, 03: 2TH)
4
Press button to save.
5
Press button and
neouslly for more than 3 seconds After the
setting has been completed.
!
NOTE
❈ The function of 2TH has difference op-
eration characterics according to prod-
uct.
• Cooling: Operation of higher tempera-
ture by comparing indoor unit's and
wired remote controller's temperature.
(there are products that operate at a
lower temperature.)
• Heating: Operation of lower temperature
by comparing indoor unit's and wired re-
mote controller's temperature.
button Simulta-
Function Code
Thermistor value
button Simulta-