Ceiling Height Selection; Static Pressure Setting - LG PQRCHCA0Q Manual De Instrucciones

Ceiling Height Selection

This function is to adjust FAN Airflow rate ac-
cording to ceiling height (For ceiling type prod-
uct)
1
Press button and
neouslly for more than 3 seconds.
2
Setup function code '05' pressing by
button.
3
Set Thermistor value by pressing button by
pressing temperature button.
(01: Remote Controller, 02: Indoor, 03:
2TH)
4
Press button to save.
5
Press button and
neouslly for more than 3 seconds After the
setting has been completed.
!
NOTE
• Ceiling height setting is available only for
some products.
• Ceiling height of "Very high" function
may not exist depending on the indoor
units.
• Refer to the product manual for more
details.
button Simulta-
Function Code
Thermistor value
button Simulta-
INSTALLATION INSTRUCTION

Static Pressure Setting

This function is applied to only duct type. Set-
ting this in cases will cause malfunction.
1
Press button and
neouslly for more than 3 seconds.
2
Setup function code '06' pressing by
button.
3
Set Thermistor value by pressing button by
pressing temperature button.
(01: V-H, 02: F-H, 03: V-L, 04:F-L)
Pressure
selection
01 V-H
02 F-H
03 V-L
04 F-L
4
Press button to save.
5
Press button and
neouslly for more than 3 seconds After the
setting has been completed.
13
button Simulta-
Function Code
Value
Function
ESP
Zone
standard
state
value
Variable High
Fixed High
Variable Low
Fixed Low
button Simulta-