Blade Attachment - Hinkley VANTAGE Manual De Instrucciones

BLADE ATTACHMENT

10 | hinkley.com
Screws
Rubber Washers
Blades
Screws
Place rubber washer on screw. Insert this assembly
1
through the blade and start the screw into the blade
arm. Repeat this procedure without tightening the
screw until all 3 screws have been started into the
blade arm.
NOTE: Make sure that concave side of blade is facing
down.
2
Tighten each screw starting with center screw.
Fasten blade assembly to motor with provided screws
3
and lockwashers. Repeat procedure for remaining
blades. Make sure screws are TIGHT! Loose motor
screws can contribute to unnecessary hum during
operation.
NOTE:
Cordless power screwdrivers are
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
NOT recommended,