Service Instructions - Gastrorag IM-88 Manual De Instrucciones

EN

Service instructions

Service instructions
AUTOFLUSH MODE
This mode should be started before the first use of the device
and after a long period of inactivity.
STEP 1
1. Fill the tank with water and vinegar in a ratio of 1:1.
2. In the standby mode press and hold the ON/OFF button for 5
seconds. A beep will sound and the symbols of all three ice cube
sizes will start flashing.
3. In the autoflush mode, the pump will run continuously, the ice
compartment will be automatically filled with water and emptied
5 times.
4. At the end of the procedure a beep will sound and the device will
go into the standby mode.
STEP 2
1. Unscrew the plug of the drainage hole and carefully drain the
cleaning solution out of the tank.
2. Fill the tank with clean drinking water to the MAX mark.
3. In the standby mode press and hold the ON/OFF button
for 5 seconds to reactivate the autoflush mode in order to rinse
the device.
4. At the end of the procedure a beep will sound and the device
will go into the standby mode. Unscrew the plug of the drainage
hole and drain the water from the tank. Leave the lid open to let
the device dry.
10