Cleaning And Maintenance - Gastrorag IM-88 Manual De Instrucciones

EN

Cleaning and maintenance

minutes. Please note the time taken to freeze, can be affected by
the room temperature and the time that the unit has been running.
5. When the ice attains its proper size, the freeze tray starts to empty
any unused water into the reservoir. Simultaneously, the heat
exchanger begins to reverse itself and as a result the prongs start
heating up to a certain degree, so that ice pieces start falling off
the prongs and fall down into the storage basket above the water
reservoir.
6. The amount of ice stored in the storage basket is monitored by the
second sensor. The system shuts off before the basket gets full.
Cleaning and maintenance
Any maintenance works on the device shall be performed
by qualified personnel only. Contact an authorized service
representative.
1. Before cleaning the device, it must be disconnected from the
power supply network and the power cord shall be unplugged
from the socket.
2. Wipe the external and internal surfaces of the device with a
clean damp cloth.
3. Water tank cleaning:
• Unscrew the plug of the drainage hole and drain the water
from the tank.
• Fill the tank with clean drinking water, wipe the surfaces of the
tank with clean cloth, run the water off.
• Continue the procedure until the water flowing out of the
drain hole is clean. Run the water off completely and secure
the plug tightly.
12
CAUTION