TECO 40 TOP Manual De Uso página 111

- Position the bead presser tool near the bead breaker roller (approximately 3-4cm).
Lower it until the bead reaches the height of the rim groove (Fig. 34b).
Risk of crushing. Positioning the bead-pressing tool against the tyre could
be dangerous in some respects. Never place any part of the body, particularly
hands between tools and wheel.
- As the turntable turns, the bead pressing tool will revolve with the tyre, keeping the
bead inserted inside the rim groove and thus avoiding any effort or danger to the opera-
tor and for the rim.
Proceed with care in this stage to avoid applying excessive stress to the tyre. It
is recommended to slightly lift up the presser tool at 6 o'clock in order to release
a little bit the pressure on the tyre bead.
- Once the mounting phased is complete, raise the bead presser roller and the bead
presser tool (control
- Return the lever-less head into its rest position (control
If the sector of the tyre bead placed between bead presser tool and roller is not
kept correctly inserted in the rim groove, it is recommended to use a supple-
mentary bead pressing clamp (optional).
User's manual
WARNING
34a
WARNING
).
NOTICE
34b
).
111
EN