Caring For The Heart Rate Monitor; Hrm-Swim Specifications - Garmin HRM-Swim Instrucciones

The O-ring gasket should remain around the outside of the
raised plastic ring.
6 Replace the front cover and the four screws.
Observe the orientation of the front cover. The raised screw
should fit in the matching raised screw hole on the front
cover.
NOTE: Do not overtighten.
7
Replace the sleeve.
After you replace the heart rate monitor battery, you may need
to pair it with the device again.

Caring for the Heart Rate Monitor

A buildup of sweat and salt on the strap can decrease the ability
of the heart rate monitor to report accurate data.
• Rinse the heart rate monitor after every use.
• Hand wash the heart rate monitor after every seven uses,
using a tiny amount of mild detergent, such as dishwashing
liquid.
NOTE: Using too much detergent may damage the heart rate
monitor.
• Do not put the heart rate monitor in a washing machine or
dryer.
• When drying the heart rate monitor, hang it up or lay it flat.

HRM-Swim Specifications

Battery type User-replaceable CR2032, 3 V
Battery life Up to 18 mo. (approximately 3 hr./wk.)
Operating temperature From -10° to 50°C (from 14° to 122°F)
range
Radio frequency/protocol 2.4 GHz ANT+ wireless communications
protocol
Water rating 5 ATM*
*The device withstands pressure equivalent to a depth of 50 m.
For more information, go to www.garmin.com/waterrating.
Limited Warranty
The Garmin standard limited warranty applies to this accessory.
For more information, go to
.html.
Installation Instructions
NOTICE
www.garmin.com/support/warranty
3