Assembly Instructions; Safety Instructions For Kitchen Unit Fitters; Installation; Cutting Out The Worktop - bora CC 21 Instrucciones Para El Uso Y Montaje

Assembly instructions

Safety instructions for kitchen unit fitters

Assembly instructions
• Veneers, adhesives and plastic surfaces of surrounding
furniture must be temperature resistant (>75°C). If the veneers
and surfaces are not sufficiently heat resistant they can
become deformed.
• Ensure that all live connections are safely insulated when
installing the hob.
• Cover strips between the wall and the worktop behind the hob
which are made of solid wood are permissible as long as
minimum clearances in accordance with the installation
diagrams are maintained.
• Minimum clearances of the hob cut-out towards the rear are to
be maintained in accordance with the installation diagram.
• For installation directly next to a tall cupboard, a safety
distance of at least 50 mm must be ensured. The side surface
of the tall cupboard should be fitted with heat resistant
material. Due to working requirements, however, the distance
should be at least 300 mm.
• The packaging materials (plastic foil, polystyrene, nails etc.)
must be kept out of reach of children as these parts are
potentially dangerous. Small parts can be swallowed and there
is a danger of plastic sheeting causing suffocation.

Installation

Important information
• If the cooking surface is located above furniture parts (side
panels, drawers, etc.), then an intermediate shelf must be
inserted at a minimum distance of 20 mm in order to prevent
accidental contact with the underside of the cooking surface.
The intermediate shelf may only be removed with tools.
• To avoid danger of fire, make sure that no combustible objects
which could easily catch fire or become deformed on exposure
to heat are placed directly next to or above the hob.
Sealing of the hob
The hob sealing included is to be properly inserted before
installation.
• No liquids may penetrate between the edge of the hob and the
worktop or between the hob and the wall and come into
contact with any electrical appliances.
• When installing a hob into an uneven worktop, e.g. with a
ceramic or similar covering (tiles etc.), the seal on the hob is to
be removed and the seal between the hob and worktop made
with plastic sealing materials (putty).
26
Working surface cut-out
Cut out the worktop recess accurately with a good, straight saw
blade or recessing machine. The cut edges should then be
sealed so that no moisture can penetrate.
The area is cut out as illustrated.
The glass ceramic hob must have a level and flush bearing. Any
distortion may lead to fracture of the glass panel. Make sure that
the sealing of the hob is properly seated.

Cutting out the worktop

The cut-out is produced in two work steps.
1. Making the opening for the base pan.
2. Making the recess for the support of the glass ceramic hob.
For this model at least one recessing machine with a guide
strip is required.
Please note:
For plastic and wooden worktops it is recommendable not to mill
out the groove too deeply or to mount the hobs with a slight
projection in order to protect the worktop surface from having hot
pots/pans unintentionally placed on it.
In order to ensure that it is exactly flush with the stone worktop,
the recess may have to be modified accordingly.
GB