Installation With A Bracket; Gluing In The Hobs - bora CC 21 Instrucciones Para El Uso Y Montaje

Assembly instructions

Installation with a bracket

[mm]
short screw
long screw
• Insert the hob and align it.
• From the bottom, insert the brackets with screws in the holes
provided for fastening the brackets, align the brackets and
screw them tight.
• Tighten the screws with a hand screw driver only; do not use a
battery-operated screw driver.
• In the case of thin worktops make sure that the brackets are
correctly positioned. A metric screw must be used on the
bracket to balance it.
Important:
There is a risk of breakage if the hob is canted or subjected to
stress during installation!
28

Gluing in the hobs

Notes
• In order to avoid damage to the worktop and the hob, it is
• The parts to be glued together must be dry and free from
Bracket
• To glue the hob, you require the water-proof wash primer and
• It is absolutely necessary to observe the enclosed
• Only glue the hob on its outer edges!
• With stone worktops installation is to be flush, with heat-
• Never place the hob with the glass ceramic surface
Procedure
1. Glue the sealing tape
2. Insert the hob without any glue into the worktop opening and
3. Remove the hob again.
4. Use the wash primer to pre-treat the outer edges of the hob
5. Now insert the hob and align.
necessary to glue the system worktop/hob with a permanent
seal so that it is water-proof.
grease.
the heat and moisture-resistant silicone adhesive (150?).
processing instructions for the two materials.
Here you will also find a calculation formula for the hardening of
the silicone adhesive. Do not operate the cooking zone
before the hardening process is over as otherwise the
silicone adhesive can be damaged.
sensitive worktops (e.g. wood) the hob must project about 1
mm.
unprotected on the worktop or the floor. Dirt (metal chips, small
pieces of stone etc.) can cause scratches on the surface of the
glass ceramic hob. Please always place it on cardboard or a
wool rug.
edge of the worktop so that no silicone adhesive
pressed under the hob.
Important: Only use the sealing tape that is supplied with the
hob! Should you use any other sealing there is no guarantee
that the hob will not sink down after installation.
check the height.
and the side cut surfaces of the worktop where they have
been glued.
Apply a thick coat of the primer with a brush on highly
absorbent surfaces (e.g. chipboard). With less absorbent
surfaces (e.g. marble or granite) it is sufficient to apply the
primer with a felt cloth.
Important: After application, the primer must be left for about
30 minutes.
GB
onto the corner of the supporting
can be