Stem Izon Guia De Inicio Rapido página 37

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

INTERNATIONAL COMPLIANCE
USA
Modifying the equipment without Stem Innovation ,LLC approval may
result in the equipment no longer complying with FCC requirements for
Class B digital devices. If this happens, your right to use the equipment
may be limited by FCC regulations and you may be required to correct any
interference to radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a
Class B Digital Device, pursuant to part 15 of the FCC rules. These limits
are designed to give reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in this
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
n
Increase the separation between the receiver and the equipment.
n
Connect the equipment into an outlet on a circuit different from that to
n
which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject
n
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation.
This product has been evaluated for RF exposure for humans in
accordance with ANSI (American National Standards Institute)
specification C95.1 limits. The evaluation was performed per FCC OET
Bulletin 65C rev 01.01. To maintain compliance, the minimum separation
distance from the Unit to the general bystander is 7.9 inches (20 cm).
37

Publicidad

Tabla de contenido
loading

Tabla de contenido