To Throw Snow - Sears CRAFTSMAN 536.886121 Manual De Instrucciones

/1111 i IIH,
O
TO MOVE FORWARD AND BACKWARD
@ To shift, re]easethe tractiondrive lever and movethe
speed shifter lever to the speed you desire, Ground
speed is determined by snow conditions,, Select the
speed you desire by moving the speed shifter lever
(eft intothe appropriatenotchon the shiftlever plate:
Speeds 1, 2 - Wet, Heavy, Extra Deep
Speed 3 - Light
Speed 4 - Very Light
Speeds 5, 6 _ Transport only
• Engage the traction drive lever (See Fig 11, left
hand)_ As the snow thrower starts to move, maintain
a firm hold on the handles, and guide the snow
thrower along the clearing path Do not attempt to
push the snow thrower.
@ To move the snow thrower backward, move the
speed shifter lever right into first or second reverse
and engage the traction drive lever (left hand).,
IMPORTANT: NEVER MOVE THE SPEED SHIFTER
LEVER WHILE THE TRACTION
LEVER IS DOWN
TO THROW SNOW
@ Push down the auger drive lever (See Fig. 11, right
hand)
@ Release to stop throwing snow.
TO USE WHEEL LOCKOUT PIN
® The left hand wheel is secured to the axle with a klick
pin (See Fig_ !2A). This unit was shipped with this
klick pin in the locked (through wheel hole) position_
Q For ease of maneuverability in light snow conditions,
disconnect the klick pin from the wheel locked position
and push into the single wheel drive (unlocked axle
hole only) position (See Fig. t2B).
® Make sure that the klick pin is in the single wheel
drive position of the axle only and not through the
locked position
ATION
TRACTION DRIVE
LEVER
AUGER DRIVE
LEVER
\
HAND
FIGo 11
KUCK PIN
/ RIGHT
HAND
LOCKED
POSITION
2-WHEEL DRIVE
FIG, 12A
KLICK PiN
UNLOCKED
POSITION
SINGLE WHEEL DRIVE
FIG. 12B
12