Equipping The Robo Wh 650 Torch Neck - Binzel WH Instructivo De Servicio

6 Putting into operation
NOTICE
• Please take note of the following instructions:
 3 Product Description on page EN-5
All torch necks are available optionally with sensor. For the control line connection, please refer
to the connection diagram.
6.1 Equipping the ROBO WH 241D, WH 455D torch neck
1
1 Gas Nozzle
2 Welding spatter guard
Fig. 7 Equipping the ROBO WH 241D and ROBO WH 455D torch neck
1 Screw the replaceable tip adaptor (4) into the torch neck (5).
2 Screw the contact tip (3) into the tip adaptor (4) and tighten it using a multiple wrench.
3 Screw the welding spatter guard (2) into the torch neck (5).
4 Slide the gas nozzle (1) on the torch neck (5) rotating it slightly clockwise.
5 Screw in the ready-to-use equipment kit (6) on the connection side.

6.2 Equipping the ROBO WH 650 torch neck

1
1 Gas Nozzle
2 Welding spatter guard
Fig. 8 Equipping the ROBO WH 650 torch neck
1 Screw the contact tip (3) into the tip adaptor (4) and tighten it using a multiple wrench.
2 Screw the welding spatter guard (2) into the torch neck (5) .
3 Slide the gas nozzle (1) on the torch neck (5) rotating it slightly clockwise.
4 Screw in the ready-to-use equipment kit (6) on the connection side.
EN - 12
2 3 4
3 Contact tip
4 Tip adaptor
2 3 4
3 Contact tip
4 Tip adaptor
5
5
6
5
5
6
WH / WHPP
6
Torch neck
Equipment kit
6
Torch neck
Equipment kit
BAL.0014 • 2019-01-16