Delete All Chases - Beamz DMX240 Manual De Instrucciones

2.4 DELETE A CHASE

2.5 DELETE ALL CHASES

3.0 ASSIGN/REVERSE DMX CHANNEL
3.1 ASSIGN DMX CHANNEL
12
1. Select the chase you wish to delete.
2. Press and hold down the Auto/Del button. Tap the Chase button while holding down the
Auto/Del button, all LEDs and the Segment Display will flash three times briefly indicating
this chase has been deleted.
1. With the power off, press and hold down the Auto/Del and Bank Down buttons at the
same time.
2. Apply the power again.
1. Program enable.
2. Press the Fine and Mode buttons at a time, the Assign LED light up indicating Assign mode is
active.
3. Use Bank Up/Down button to change between the Pan and Tilt, the corresponding LED lights
indicating this selection,
4. Tap the Tap/Display button to change between 8CH. And 16Ch. Mode, the LCD Reads
ASSXX XX
X/Y  08CH
5. Tap the fixture button to select the fixture.
6. Tap the page select button to select page A or page B.
ASSXX XX
X/Y  16CH