Beamz DMX240 Manual De Instrucciones página 13

3.2 REVERSE DMX CHANNEL
3.3 FADE TIME/ASSIGN FADE TIME
7. While pressing the mode button, tap the Scene button, all LEDs should flash
briefly indicating the D MX channel is assigned. (Scene button 1 stands for DMX
channel 1, Scene button 2 stands for DMX channel 2, and so on.
8. Continue steps 3-7, you may assign a maximum of 48 DMX channels for 12
fixtures.
1. Program enable.
2. Press the Fine and Mode buttons the second time, the Reverse LED lights up
indicating Reverse mode is active.
3. Use bank Up/Down button to change between the Pan and Tilt, the
corresponding LED lights indicating this selection.
4. Tap the Tap/Display button to change between 8CH. and 16 Ch. Mode.
5. Tap the scanner button to select the scanner.
6. Tap the page select button to select page A or page B.
7. While pressing the mode button, tap the Scene button, all LEDs should flash
briefly indicating the DMX channel is assigned. (Scene button 1 stands for DMX
channel 1, Scene button 2 stands for DMX channel 2, and so on.
8. Continue steps 3-7, you may assign a maximum of 48 DMX channels for 12
fixtures.
1. With the power off, press the mode and TAP/Display buttons at a time.
13