Rear View - Beamz DMX240 Manual De Instrucciones

REAR VIEW

1. Audio in
0.1V – 1Vp-p
2.Midi in
Receives MIDI data.
3. DMX Polarity select
Make sure the polarity of your fixture.
4. DMX Out
This connector sends your DMX value to the DMX scanner
or DMX pack.
1.0 OPERATION GUIDE
GENERAL
This unit allows you to program 12 scanners of 16 DMX channels, 30 banks of 8 programmable scenes, 6 chases of 240
programmed scenes using 8 faders and other function buttons. With the use of two jog wheels, you may easily control the Pan
or Tilt of the fixtures. To tailor your special effect lighting, this unit enables you to assign or reverse the DMX channels. In
addition, two or more units can communicate with each other so that they can send or receive file dump.
Display Information
The LCD Display contains a maximum of 2x8 characters.
LCD Display
Chase 5
Step 002
Data 151
SP: 1M36S
TP: 5.32S
FT: 10.5S
ASS 07 08
RES 10 13
SN 6
BK 03
1.1 PROGRAM ENABLE
6
Message
Chase 5 is activated.
nd
The 2 step of a chase
DMX value(000-255)
The current speed is 1 minute and 36 seconds
The time of the last two taps is 5.32 seconds
Fade time is 10.5 seconds
Assign DMX channels 7 and 8
Reverse DMX channels 10 and 13
Scene 6
Bank 03
When the power is turned on, this unit enters Manual mode automatically. Press the Program
button for three seconds to activate Program mode, a fast blinking light in the Segment Display
next to "PROG." Indicates its selection.
5.DMX In
This connector accepts your DMX input signals.
6. DC Input
DC 9 – 12V, 300mA
7. USB
For connect a USB lamp
8. Power Switch
This switch turns On/Off the power.