Beamz DMX240 Manual De Instrucciones página 5

OVERVIEW
1. Fixture buttons (1 – 12)
Used to select relevant fixture for control.
2. Scene buttons (1-8)
Press the scene buttons to load or stored your scenes.
There are a maximum of 240 programmable scenes.
3. Segment Display
Shows the current activity or programming state.
4. Bank Buttons (Up/Down)
Press the Up/Down buttons to select a bank from 30 banks.
5. Chase Buttons(1-6)
Used to select your programmed chase consisting a
maximum of 240 scenes.
6. Program Button
Used to activate Program mode.
7. MIDI/Rec Button
Used to control MIDI operation or to record programs.
8. Auto/Del Button
Used to activate Auto mode or to delete scenes and
chases.
9. Music/Bank Copy
Used to activate Music mode or to create scenes and
chase programs.
10. Blackout Button
Used to disable channel output.
11. Tap Sync/Display
Used to create a standard beat or to change the values
display between % and 255.
12. Fade Time Slider
Used to adjust the Fade Time. Fade Time is the amount of
time it takes for a fixture(scanner) to move from one
position to another, for the dimmer to fade in or fade out.
13. Speed Slider
Used to adjust the speed at which the scenes will chase.
14. Page Select Button
Used to select faders for the fixture between Page A(1-8)
and Page B (9-16).
15. Faders
This faders are used to control the intensity of channel 1-8
or channel 9-16 depending upon the selected page.
16. Fine Button.
When Fine is on, the Pan or Tilt wheel will control the
scanner in the smallest increment.
17. Pan Wheel
This jog wheel is used to control the pan of the fixture or for
programming.
18. Mode button
Pressing Fine and Mode buttons allows to activate Assign
or Reverse mode.
19. Tilt Wheel
This jog wheel is used to control the Tilt of the scanner or
for programming.
5