b) Control Panel Description
1. REMOVABLE HDD CARTRIDGE & KEYHOLE
2. CAMERA:
press one of the buttons to select that channel
3. REC:
to start recording immediately.
4. PLAY:
to play recorded video.
5. PAUSE/▲: pauses the fragment. In setup mode it works as an up button.
6. STOP/▼:
stops playback or recording. In setup mode it works as a down button.
7. REW /◄:
to rewind in PLAY and PAUSE mode. In setup mode it works as a left button.
8. FF / ►:
to wind forward in PLAY and PAUSE mode. In setup mode it works as a right button.
9. LEDs:
HDD: HDD status
HDD FULL: HDD is full
ALARM: alarm is armed (when alarm is triggered, LED is flashing)
TIMER: the device is programmed to record
PLAY: recorded material is being reproduced
REC: the device is recording
10. MENU:
Press this key to access the main menu.
11. ENTER:
to confirm data or a selection.
12. SEARCH:
opens the search menu
13. ZOOM:
press ZOOM to enlarge the displayed picture
14. PIP/+:
Press once for PIP, twice for POP. In setup mode it works as a "+" button to change a value.
15. QUAD/-:
displays all 4 channels simultaneously. In setup mode it works as a "-" button to change a value.
16. SLOW:
slows down the play speed.
17. POWER:
Press this button to power on, and press it again to power off.
c) Back Panel Description
18. POWER: connect the provided adapter to this connector and plug it into the mains.
19. External I/O: the device can be controlled remotely by an external device or trigger mechanism.
20. VIDEO inputs 1-4: to connect video sources such as cameras.
21. MAIN MONITOR: to connect the main monitor.
22. CALL MONITOR: to connect the call monitor. This monitor will show the triggered channel in case of an alarm.
23. AUDIO IN: 1 input per channel. Only 1 input can be recorded during 1 session. Only available when IPS≥25.
24. AUDIO OUT: 2 mono audio outputs. Only available when IPS≥25.
25. FAN: for ventilation purposes ; do not block this opening
DVR4MQA
- 5 -
VELLEMAN