Adam Equipment Nimbus NBL Serie Manual De Instrucciones página 40

Press [Setup]. "" will be displayed. Enter the current passcode (OLD) first

and press [Setup]. If correctly entered then "" will be displayed briefly
followed by "". Enter a new passcode if desired or press [Mode] or
[0/T] to leave the existing password unchanged and return to normal
weighing.
Note: A passcode set to zero will disable the security feature and allow
unlimited access.
 Press [Setup]. "" will be displayed. Enter the current passcode (OLD) first
and press [Setup]. If correctly entered then "" will be displayed briefly
followed by "". Enter a new passcode if desired or press [Mode] or
[0/T] to leave the existing password unchanged and return to normal
weighing.
Note: A passcode set to zero will disable the security feature and allow
unlimited access.
If a passcode is incorrectly entered then the message "" will flash and the display
will return to "" or "".
Forgotten Passcodes:
Keep a record of the passcode to ensure you can access this section again. If however
you have forgotten your passcode you can still gain access by entering a universal code.
If you have forgotten the current passcode a code of "15" will always allow you to enter the
Supervisor area. Using the Supervisor menus, go to PASSCODE section. Reset the
Operator or Supervisor passcode using "" as the old passcode when prompted.
© Adam Equipment Company 2017
38