Operating Instructions; Starting Treatment - ResMed AutoSet Spirit Manual Del Usuario

O
PERATING
S T
TARTING REATMENT
The A S S
UTO ET
mask system connected. See "Setting Up The AutoSet Spirit" on page 11.
1
Turn the main power switch at the back of the unit to on (I).
When the A
UTO
screen. The Ramp or Settling screen then appears, depending on whether your
machine is in CPAP or AutoSet mode.
Note: If you have the HumidAire 2i attached, please refer to the HumidAire 2i User's
Manual for operating instructions.
2
Fit your mask as described in the mask user instructions.
WARNING
!
Before starting therapy ensure that you are wearing the mask and that the mask and
air tubing are fitted correctly.
3
Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
CAUTION
!
Do not leave long lengths of air tubing around the top of your bed. It could
•
twist around your head or neck while you are sleeping.
Make sure the area around the flow generator is dry and clean. It should also be
•
clear of bedding, clothes, and other potential blockages.
4
To start treatment, press the Front key
or
if your clinician has enabled the SmartStart function, simply breathe into the mask and
treatment will begin.
After starting treatment, the treatment pressure is displayed on the LCD.
Note: Pressure displayed on the LCD during therapy is the intended delivery pressure.
I
NSTRUCTIONS
unit should be assembled beside your bed with the air tubing and
PIRIT
S S is turned on, a welcome message is displayed on the LCD
ET PIRIT
O I
PERATING NSTRUCTIONS
23