Measure Energy Consumption; Display Co2-Emissions; Show Total Energy Costs - brennenstuhl EM 235 Instrucciones De Utilización Y De Seguridad

Operation
Press and hold the FUNC-Button
i
counters for maximum power consumption, date and time back to 0.

Measure Energy Consumption

q
Press the FUNC-Button
i
appear in the LC-display
The LC-display
i
all electrical devices connected.
Note: The measureable range lies between 0.00 und 9,999.99 kWh. If this
value is exceed, the indicators ---- and OVER appear in the LC-display
The LC-Display
i
Press and hold the FUNC-Button
i
counters for energy consumption to 0.

Display CO2-Emissions

q
Press the FUNC-Button
i
appear in the LC-display
The LC-Display
i
the electrical devices connected.
Note: The LC-Display
after 60 seconds.
The LC-Display
i

Show Total Energy Costs

q
Note: Make sure that you have entered the values for electricity tariff 1 or electricity
tariff 2 in the first field (see "Enter Electricity Tariff 1" or "Enter Electricity Tariff 2"). Other-
wise, the energy cost measurement device cannot calculate the total costs.
Press the FUNC-Button
i
TIME are shown in the LC-display
30 GB
Steckdosenleiste_Content_DE_GB_NL_SE_ES.indd 30
for about 2 seconds long in order to set the
3
until the kWh and POWER FACTOR indicators
3
.
2
now shows the total energy consumption in kilowatt hours for
2
also shows the power factor.
2
for around 2 seconds in order to re-set the
3
, until the indicators CO2 / kg and POWER FACTOR
3
.
2
now shows the total CO2-emissions in kilograms generated by
2
will automatically switch back to the standard display
2
also shows the power factor.
2
until the indicators TOTAL PRICE and TOTAL ON
3
.
2
.
2
23.07.14 13:23