Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
QuickTree® settings for Vertical Discharge Pro370 and Pro380 Systems:
When servicing the QuickTree
clamp. Tighten the screw with a Phillips screw driver, being sure not to over tighten. Flats have been stamped on the rod to designate
float position, and the screw should be tightened onto the flat. The tether length is the amount of cord between the clamp and float.
TETHER LENGTH (SWITCH TO CLAMP)
ROD
POSITION Alarm Float Control Float Alarm Float Control Float
1
2
3
4
®
, place the switch cord into the trough or channel and then slip the stainless steel rod through the
©Copyright 2015 Liberty Pumps Inc. All rights reserved
Pro370
3.5"
3.5"
Pro380
3.5"
3.0"
6
Publicidad
Capítulos
Tabla de contenido
