Page3 Timer; Page4 Clone - Marantz RC1400 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

D2 I-TIME:
This is used when setting the transmission
interval (interval time) for macro programs. It
can be set from 0.5 to 5 seconds and is set
using the cursor buttons.
D3 CONT:
This is used to change the contrast of the LCD.
It can be adjusted to one of 10 levels and is set
using the cursor buttons.
D4 CLOCK:
This is used to set the current time.

PAGE3 TIMER

The macro timer setting is performed from this
menu.
D1 DAILY?:
This is for using the timer function to execute a
macro. Use DAILY when a program will be
executed at the same time each day.
D2 ONCE?:
This is for using the timer function to execute a
macro. Use ONCE when a program will be
executed only once.
D5 CANCEL:
This is for using the setting time to cancel.

PAGE4 CLONE

The Clone mode settings are made from this
menu.
D1 RX:
This is used on the receiving unit (slave) when
copying all of the programmed information
from another RC1400 remote control.
D2 RX-S:
This is used on the receiving unit (slave) when
copying the programmed information for
selected source from another RC1400 remote
control.
D3 TX:
This is used on the sending unit (master) when
copying information to another RC1400 remote
control.
9
RC1400N 01 ENG
Adobe PageMaker 6.5J/PPC
Page 9
03.10.6, 4:17 PM

Publicidad

Tabla de contenido
loading

Productos relacionados para Marantz RC1400

Tabla de contenido