Marantz RC1400 Manual De Uso página 41

1
2
3
4
5
6
7
8
9
10
11
RC1400N 01 ENG
Place the receiver sensor of the receiving
remote control (top) so that it is facing the
transmitter of the transmitting remote
control (top) at a distance of about 5 cm (2
inches).
Hold down the M button r of the
transmitting remote control for three
seconds or more.
The menu is displayed.
Press the > button y to display the fourth
page CLONE menu.
Press the D3 (TX) direct button t.
The transmitting side is now ready.
Hold down the M button r of the receiving
remote control for three seconds or more.
Press the > button y to display the fourth
page CLONE menu.
Press the D2 (RX-S) direct button t.
Press the source button !4 to be copied.
The receiving side is now ready.
The name of the source which was pressed is
displayed on the LCD.
• Each time the source button is pressed, the name
is displayed on the LCD.
Press the OK cursor button @0 on the
receiving remote control.
Press the OK cursor button @0 on the
transmitting remote control.
When copying is started, the bar indicators on both
LCDs start to move from the left to the right.
• When the copying operation is completed, TX
OK is displayed on the LCD of the transmitting
remote control, and RX OK is displayed on the
LCD of the receiving remote control.
• Do not touch either of the remote controls during
the copying operation. Doing so could cause
copying to fail.
• If the copying fails in the middle of the copying
process, ERROR is displayed on the remote
control.
Check and perform steps 1 to 7 again.
Once copying is completed, press the M
button r on both remote controls.
40
Page 40
Adobe PageMaker 6.5J/PPC
03.10.6, 4:19 PM