Setting The Parameters - Beta RR 390 Manual De Uso

SETTING THE PARAMETERS

General information:
Allowed settings:
• Km/h (kilometres per hour) or M/h (Miles per hour)
• Wheel size (rolling circumference) [mm]
• Clock format: 12-hour / 24-hour
• Current date
• Maintenance
TO ENTER THE PARAMETER SETTINGS MODE HOLD DOWN THE RIGHT AND LEFT
BUTTONS FOR APPROX. 3s.
THE WORD "Unit" WILL FLASH ON THE DISPLAY.
The operational logic is structured as follows:
• The instrument enters SETUP mode displaying the parameters according to the
sequence listed above.
• The instrument displays the parameter to be changed for a few seconds in flash
mode.
• If you wish to change the parameter displayed for those few seconds simply
edit the values by pressing the right and/or left buttons (according to the modes
listed below), otherwise wait a few seconds (approx. 5 s) to proceed to the next
parameter.
• When the parameter has been edited to the desired value, the instrument au-
tomatically moves onto the next setting, there is no need to press any button of
confirmation.
• If you only wish to enter the setup mode to view the configured settings, simply wait
without pressing any buttons; the instrument will display all of the set parameters
and will then automatically go back to "Normal Mode".
SETUP SEqUENCE
Select unit of measure
Wheel size
Clock format
Current date
Maintenance
15
1
GB