Pipe Mounting The Light; Surface Mounting The Light; Figure 2 Mounting Options - Federal Signal Commander 371LEDX-120 Manual De Instalación Y Mantenimiento

Pipe Mounting the Light

Attach the light to the 1-inch NPT pipe by threading the light
clockwise on the pipe (Figure 2). For information on making
the electrical connections, see "Wiring the Light" on page 12.
PIPE MOUNT
1" NPT
PIPE

Surface Mounting the Light

To mount the light on a flat surface:
1. Using the gasket as a template, scribe four drill-position
marks on the mounting surface (Figure 2).
2. Drill a 9/32-inch (7.1 mm) diameter hole at each of the
outside drill-position marks for mounting.
3. Drill or punch a 1-3/8 inch (34.9 mm) diameter hole at the
center drill-position mark for the wire entry.
Model 371LEDX-120 Rotating Light
Installation and Maintenance Instructions
Figure 2 Mounting options
GASKET
DRILL THREE 9/32"
(7.143 mm) HOLES
MOUNTING
SURFACE
1/4" FLATWASHERS
1/4" SCREWS
SURFACE MOUNT
290A7464
9