Chapter 8 - Operation And Use - TECO 320 Manual De Instrucciones

CHaPTEr 8 - oPEraTioN aND USE

2
The commands for using the lift are:
Main switch (1)
The main switch has two positions:
Position 0: the lift wiring circuit is not powered; it is possible to secure the switch using
a metal padlock to prevent its use.
Position 1: the lift wiring circuit is powered.
Down button (2)
If pressed, it activates the down valve on the hydraulic unit and allows the lift to go down.
Final lowering (3) - only for the recessed version.
If pressed before detecting the safety height (500 mm), together with the down button
(2), it activates the horn but blocks the lowering of the lift.
If pressed after detecting the safety height, together with the down button (2), it activates
the horn and the down valve on the hydraulic unit for the final travel.
Lift operation can be summarized into four steps:
Place the vehicle at the centre of the platform and adjust the telescopic extensions.
Place pads under the positions indicated by the motor vehicle's manufacturer for lifting.
Turn the main switch (1) and keep it in position 1 until reaching the desired height.
EN - Operator's manual
8.1 Controls
Be sure the safety area is free from people and objects during
the final travel.
8.2 Vehicle positioning
8.3 Lifting
8
3
1
59