Virtus CUTTER 06 Manual Del Usuario página 32

8.9 - Replacement of spare parts
Contact your local dealer should you need to order spare parts. Do not use spare
parts that are not original. Please remember that the machine must be assembled by
qualified personnel only.
9 Troubleshooting
9.1 - Troubleshooting
Problem(s) Cause(s)
The machine does not The circuit breaker is set to "0".
start.
The lid is not locked.
The tank is missing.
The cutter's tank or lid
microswitch is not working.
The electric motor or the
electrical board are defective.
The buttons will not start the
blades.
Solution(s)
Turn the main switch to
"1".
Lower the lid and turn
the knob counter-
clockwise.
Assemble the tank,
fastening it correctly to
the pull mechanism.
Contact customer
service.
Contact customer
service.
Contact customer
service.
26
INDEX
1. Delivery and warranty
1.1 - Introduction
1.2 - Storage and use of the manual
1.3 - Warranty
1.4 - Description of the machine
1.5 - Intended use
1.6 - Improper use
1.7 - Machine identification
1.8 - Safety guards and devices
1.9 - Warning and danger signs/labels
1.10 - Operating position
1.10 - Environmental conditions
1.12 - Lighting
1.13 - Vibrations
1.14 - Protective equipment
2. Technical characteristics
2.1 - Main parts
2.2 - Technical specifications
2.3 - Size and weight of the machine
2.4 - Wiring diagrams
2.4.1 - Wiring diagram of single-phase stainless steel buttons
2.5 - Noise level emitted by the machine
3. Testing, transport, delivery and installation
3.1 - Testing
3.2 - Delivery and handling of the machine
3.2.1 - BOM included with machine
3.3 - Installation site
3.3.1 - Installation
3.3.2 - Packaging disposal
3.3.3 - Handling the machine
3.4 - Electrical connection
3.4.1 - Single phase 110 Volt-60 Hz machine
4. Controls and indicators
4.1 - List of controls and indicators
5. Starting and stopping the machine
5.1 - Checking the electrical connection
5.2 - Checking for presence and efficiency of safety guards and devices
5.3 - Machine start-up
5.4 - Machine stop
5
10
16
18
19
3