Filters; Hepa Media Final Filter; Replacement Filter - Hoover HUSHTONE CH95413 Manual Del Usuario

Filters

WARNING
OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.

HEPA MEDIA FINAL FILTER

The final filters assist in the filtration process to return cleaner air to the room. This unit has been
equipped with a Service Filter Indicator. When the light flashes, follow procedures for cleaning the
HEPA final filter below.
1
To remove, push down on tab
and pull out filter housing
IMPORTANT
BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
NOTE: To reset the timer on the Filter indicator, press and hold the reset button until
light stops flashing.

REPLACEMENT FILTER

Inspect HEPA Media Final Filter every month, rinsing when necessary. Check for
wear of media and replace if pleats are damaged. Change filter regularly to maintain
maximum performance.
HEPA Media Final Filter Part No. 440007773
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING OR SERVICING. DO NOT
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON EDGE SO AIR CIRCULATES ON
2
Lift out and hand rinse in cold
water under low pressure. Rinse
only with open side facing up.
Allow to dry and reposition into
filter housing, pushing firmly on
tab to snap into place.
17