Sony SU-WL31 Instrucciones página 12

B
Screw (+PSW5 × L16)
C
Screw (+PSW5 × L16)
Retighten two screws
removed in 3 of procedure 1
in the screw holes at either
end.
D
Screw (+PSW5 × L16)
E
Screw (+PSW5 × L16)
12
(GB)
Step 6:
Installing the TV on the
Plate Unit
Be sure to complete the installation before connecting the
AC power cord to the wall outlet. If you allow the AC
Mounting Hook
Unit
power cord to be pinched under or between pieces of
equipment, this may result in a short circuit or an electric
shock.
Be careful not to stumble over the AC power cord or the
TV, as you may hurt yourself.
1
Mounting Hook
Unit
Mounting Hook
Unit
Mounting Hook
Unit
WARNING
Connect the AC power cord and
the connecting cable(s) supplied
with the TV to the TV.
Connect the AC power cord and the connecting
cable(s) to the connectors on the rear side of the
TV. For details on connecting the AC power cord
and the connecting cable(s), refer to the
instruction manual of the TV.
When you route the cord and the cable in the
wall, feed them through the hole you bored
(page 17).
Hole for cable routing
Notes
• You cannot connect the cables to the TV after
installing it on the Plate Unit.
• Subcontract the cable routing in the wall to licensed
contractors.