Tools Required - Eaton Lumark Crosstour LED Instrucciones De Instalación

Installation Instructions - Crosstour LED
INSTALLATION
Available on 7W, 18W, 26W and 38W models only.
N ote:

Tools Required

Phillips head screw driver and electrical wiring tools.
1. Unscrew door with phillips screw driver. Remove
door from back box. Confirm junction box size prior to
removing the gasket material for the application
(Figure 1). Only remove the gasket material needed
for the installation. Mount back box to junction box via
supplied hardware or lag mount. Utilize any junction
box pairings for lag mount (Example: D-D). Lag mount
hardware provided by others.
N ote: Installer must apply silicone compound around entire
perimeter of the back box where it mates to the
mounting surface. This will create a water tight seal
between the mounting surface and the back box.
(Figure 6.)
2. Secure door in lock hinges located at the top of the
back box (for down light illumination) (Figure 2). Utilize
lever-lock connectors to make electrical connections
(Figure 3). All electrical connections must remain inside
back box. Secure any lose wires to harness (Figure 4)
prior to closing and securing door. Tighten door screw
to seal fixture. (10-15 in-lbs.)
A-A 4" Square Box
B-B 4" Octagonal Box
C-C 3-1/2" Square/Octagonal
Box
D-D Masonry Box
Table 1. Junction Box Mounting Guide
N ote: For conduit applications, remove only the required
1/2" NPT conduit plug(s) prior to installing back box
to surface. Apply sealing compound or teflon tape
to liquid-tight conduit fitting (supplied by others)
entering back box to create water tight seal. Make
electrical connections (Figure 3 and Figure 4).
N ote: Installer can relocate photocontrol to any threaded
conduit back box. Sealing compound or teflon tape
must be applied to re-install conduit plugs.
2
EATON
IB514015EN
E-E 4" Round Box
F-F 2-3/4" Hole Patter
G-G Single Gang
Installation instructions
Figure 1.
Figure 2.
Optional Photocontrol
Photocontrol can be
temporarily removed if it
interferes with mounting.