Worx WG184E Manual Original página 13

OPERATION INSTRUCTIONS
WARNING! The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery
pack connections because of an electrical failure and
hazard will occur.
1. COMMAND FEEDING THE LINE
(See Fig. J)
Your grass trimmer is equipped with a Command
Feed System. Just press the button while the
machine is running, new line will feed out and then
stop when you hear the 'clattering' noise of the
new line being cut. The motor stops briefly when
the Command Feed button is pressed, and restarts
when released. This process enables the machine to
automatically feed out new line.
2. MANUALLY FEEDING THE LINE
(See Fig. K)
Turn off the trimmer and remove the battery. If
required, line can be fed out manually. To operate,
press and release manual Line Feed Button, while
gently pulling out the line until it is long enough to
reach the Line Cutter. If the line extends past the Line
Cutter, too much line has been fed out. If too much
line is fed out, remove the Spool Cap and turn Spool
counter-clockwise until the line is at the desired
length.
3. MANUALLY WINDING THE LINE
(See Fig. O, P, Q, R)
Take approximately 20ft (6m) of line. Insert 0.080 inches
(2mm )of line into the Spool holes and wind line in the
direction of the arrows on the top of the Spool. Leave
approximately 4 inches (100mm) of line unwound and
place into the cleat. Ensure that the line is neatly coiled on
the Spool. Failure to do so will impair the efficiency of the
automatic line feed. Then fit the Spool as described above
in "Replacing the trimmer line and Spool"
STORING YOUR GRASS
TRIMMER
Always remove the battery pack from
your trimmer after use.
TO STORE YOUR GRASS TRIMMER
The trimmer is provided with a hanging slot for
storing the trimmer on the wall. (See Fig. S)
Store in a dry place where the trimmer and battery
can be protected from damage.
2-in-1 Grass Trimmer/Edger
MAINTENANCE
Always remove the battery pack from
your trimmer after use.
Always check the product prior to being used for
any damage.
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in
a dry room temperature location. Keep the motor
ventilation slots clean. Keep all working controls
free of dust.
13
EN