Thermoforming - Dreve Drufosmart scan Instrucciones De Trabajo

Info
For safety reasons the quartz
radiator is equipped with a final
switch and only works in swivelled
in position after having started a
programme.
If the quartz radiator is swivelled
outwards after having started a
programme, the heating process
will be interrupted automatically.
The indication in the display (a)
will stop and show the remain-
ing time. By swivelling the quartz
radiator back in the programme
will be re-activated.

8.4 Thermoforming

After the heating time has elapsed there
will be an acoustic signal; the heating
time in the display will be 00:00. The
heating will be switched off automati-
cally. Pull the heating (4) at the handle
(5) away from the centre of the unit as
far as it will go with the right hand.
Then push the activation lever (34) with
the left hand downwards as far as it will
go. By pulling the heating handle (5)
again as far as it will go the pressure
chamber closes completely and pressu-
rising of the piston will be carried out
automatically. This is confirmed by an
acoustic signal.
Attention! The swivelling housing
of the heating element reaches
high temperatures. Therefore it
must not be touched – even not
for short moments.
After the adjusted time has elapsed
the indicator (a) in the display will
stop and count the duration after
termination of the heating time.
This process may be stopped by
successive thermoforming.
Info
For safety reasons the pressure
chamber can only be pressurised,
if it has been moved downwards
completely manually. In order to
protect the operating personnel
securely against bruises of the
fingers, pressurising can only be
effected, if the unit is operated
with two hands at the same time
(two-hand control). Always make
sure that no objects are in the con-
tact area between piston and insert
bowl while the piston is closing!
35