Optional Additional Functions; Fabrication Of Cast Form Parts; Care And Maintenance - Dreve Drufosmart scan Instrucciones De Trabajo

10 Optional additional functions

10.1 Fabrication of cast form parts

With the K-7 insert it is possible to
thermoform up to 7 resin bases for
the crown and bridge technique at the
same time. Fix the single dies by means
of a flexible blocking out material (e.
g. Fillin) in the holes of the K-7 insert.
Remove the nub plate from the insert
bowl and replace it by the K-7 insert.

11. Care and maintenance

Generally disconnect the unit from
mains supply before executing care
and maintenance.
Ideally cleaning is to be effected dryly
with a soft piece of cloth, if necessary
All further working steps as described
from point 7.1 on.
with a slightly humid sponge and a mild
cleaning liquid. Water and cleaning li-
quids must not get into the unit.
The O-rings should be greased regularly
with silicone grease.
41