Exceeding Of Entered Heating/Cooling Times; Entering A Wrong Barcode; Optional Additional Functions; Fabrication Of Cast Form Parts - Dreve Drufosmart scan Instrucciones De Trabajo

Drufosmart scan

9.6 Exceeding of entered heating/cooling times

After elapse of times adjusted regu-
larly (display position a/c) there will be
an acoustic signal. The exceeded time

9.7 Entering a wrong barcode

If a barcode is scanned that does not
correspond to the programming of the
Drufosmart scan, four acoustic warning
signals will be heard and the display will
show ERROR at position b.
40
will be blinking in the display as control
mechanism.
By scanning the correct barcode you
can proceed further, as described in
point 8.0.

10 Optional additional functions

10.1 Fabrication of cast form parts

With the K-7 insert it is possible to
thermoform up to 7 resin bases for
the crown and bridge technique at the
same time. Fix the single dies by means
of a flexible blocking out material (e.
g. Fillin) in the holes of the K-7 insert.
Remove the nub plate from the insert
bowl and replace it by the K-7 insert.
All further working steps as described
from point 7.1 on.

11. Care and maintenance

Generally disconnect the unit from with a slightly humid sponge and a mild
mains supply before executing care cleaning liquid. Water and cleaning li-
and maintenance. quids must not get into the unit.
Ideally cleaning is to be effected dryly The O-rings should be greased regularly
with a soft piece of cloth, if necessary with silicone grease.
41