Chann El Contr Ol S; M I X E R C O N T R O L S - Gemini CDMP-7000 Manual De Instrucciones

m i x e r c o n t r o l s

cHAnn eL inP UT SeLec T io n
The CDMP-7000 has three mixing channels: CH1, CH2,
CH3. Each channel has three inputs that can be selected
via the CHANNEL INPUT SELECTOR SWITCH (31) lo-
cated at the top of each channel.
• CH1 can be toggled to either use the USB INPUT,
AUX1, or AUX2.
• CH2 toggles between the left deck of the CDMP-
7000, computer audio in MIDI mode, and the LN1/
PH1 input.
• CH3 toggles between the right deck of the CDMP-
7000, computer audio in MIDI mode, and the LN2/
PH2 input.

cHAnn eL conTR oL S

Each channel of the CDMP-7000 has a rotary GAIN
CONTROL (45), a 3-BAND EQUALIZER (44), and a
VOLUME FADER (43) to make tonal and volume adjust-
ments to each channel.
The GAIN CONTROL (45) adjusts the gain of the incom-
ing signal on each channel.
The 3-BAND EQUALIZER (44) adjusts the tone of the
incoming signal on each channel across 3 bands: LOW,
MID, and HIGH.
• Use the HIGH control to adjust the treble frequencies.
• Use the MID control to adjust the middle frequencies.
• Use the LOW control to adjust the bass frequencies.
The CHANNEL VOLUME FADERS (43) are 60mm faders
that adjust the sound volume for each channel (adjust-
able from -∞ to 0 dB).
m ASTeR oUTPUT
The CDMP-7000 has a MASTER VOLUME (32) control
that adjusts the summed output of the 3 channels.
The VU METER (33) displays the the left and right out-
put levels of the MASTER OUTPUT.
*NOTE: Going above 0dB (into the red indicators) should
be avoided as the signal will distort and could damage
other equipment.
The MASTER BALANCE CONTROL (34) adjusts the L/R
channel panning on the master output.
-
c d m p 7 0 0 0 m a n u a l • g e m i n i d j
.
c o m
m i x e r c o n t r o l s
Bo oTH o UTP UT
The CDMP-7000 has a BOOTH VOLUME (49) control
that adjusts the BOOTH OUTPUT (C) level. This can
be used for many purposes including feeding a set of
speakers for monitoring or to send the signal to a differ-
ent area or feed.
h e a d p h o n e c o n t r o l s
H e AdP Ho ne c Ue ASSig n
Each channel on the CDMP-7000 has a CUE TOGGLE/
INDICATOR (35) allowing the creation of a headphone
cue mix with any combination of channels, including the
master output. By pressing the CUE TOGGLE/INDICA-
TOR (35), that channel will be assigned to the cue mix
and the indicator LED will illuminate.
H e AdP Ho ne mi X co n TR o L
The HEADPHONE MIX CONTROL (36) controls the mix
of the headphone output between the CUE mix and
PGM (master output) mix.
The HEADPHONE VOLUME CONTROL (37) controls the
volume of the heaphone signal.
The HEADPHONE OUTPUT SWITCH (38) allows tog-
gling between a full stereo mix of the CUE/PGM blend
or a mono split signal, which will put the CUE mix in the
LEFT channel of the headphone out and the PGM mix in
the RIGHT channel of the headphone out.
20