Usb Memory De Vic E Err O Rs; Tr O U B L E S H O O T I N G - Gemini CDMP-7000 Manual De Instrucciones

p l a y b a c k
t r o u b l e s h o o t i n g
cd eRR oRS
- If a disc will not play, check to see if the disc was
loaded correctly (label side up). Also check the disc for
excessive dirt, scratches, etc.
- If a disc contains a non-compliant file format causing a
playback error, press and hold the EJECT (19) button for
4 seconds. The unit will eject the disc and reboot.
- If the disc turns but there is no sound, check the cable
connections, if they are ok, check your amplifier or
receiver.
-If the CD skips, check the CD for dirt or scratches. Do
not assume that the CD layer is defective. Many CD's
are recorded out of spec and will skip on most or all CD
players. Before sending the unit for repair, try playing a
CD that you are sure plays properly.

USB memoRY de Vic e eRR o RS

Some USB devices may not operate properly with the
CDMP-7000. Gemini accepts no resposibility for any
possible data loss that may occur. To ensure that data is
not permanently lost, please make sure to backup any
data prior to connecting the USB device to the the unit.
- USB hubs cannot be used with the CDMP-7000.
- If the unit does not read the USB memory device,
check to see if the memory device was inserted
completely.
- If a "Too many devices" message appears, it is because
a USB hub is in use. The CDMP-7000 does not work with
USB hubs. Disconnect the USB hub and connect the
USB memory device directly into the CDMP-7000.
-If a "Media err. Please Check Media Format and Try
Again" message appears, this signifies that your USB
memory device is formatted incorrectly.
-
c d m p 7 0 0 0 m a n u a l • g e m i n i d j
.
c o m
t r o u b l e s h o o t i n g
S d cA Rd eR R oR S
- If the unit does not read the SD memory card, check
to see if the memory card was inserted correctly and
inserted completely.
- If a "Media err. Please Check Media Format and Try
Again" message appears, this signifies that your SD
memory device is formatted incorrectly.
mi d i eRR oR S
-If the computer does not recognize the device, try pow-
ering the unit off and rebooting the computer.
-If the DJ software does not list the device, ensure that
you are using the latest version by downloading any up-
dates to your DJ software. If the CDMP-7000 mapping
does not appear in your DJ software's list, go to gemi-
nidj.com for downloads and support.
22