Transcend 365 minicpap Auto Guía Rápida página 18

Ocultar thumbs Ver también para 365 minicpap Auto:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Transcend 365 miniCPAP Auto
Standard user modes
Normal operation consists of four modes:
Off
When the device is not connected to a power source, the device is off.
Standby
When power is applied to the device the LCD screen lights up and the CPAP
enters Standby Mode. Standby Mode is also initiated by pressing the power
button when the device is in On Mode or if the mask is removed while in On
Mode. As long as power is supplied to the device it will remain in Standby
Mode until On or Drying Mode is initiated.
On
When in On Mode, the blower is working and regulated device therapy
pressure is being generated. The LED lights remain off. On Mode is initiated by
pressing the center button when the device is in Standby Mode and the mask
is worn by the patient.
Drying
This mode is accessed from Standby mode. Press and hold the Up and Down
Mode
buttons at the same time for three seconds to start Drying Mode. This mode
will last 30 minutes unless you interrupt it by pressing any button. Drying
mode flushes your CPAP device, tubing and mask of residual moisture left from
a therapy session.
TM
Quick Guide
18
ENGLISH
Page 18

Publicidad

Tabla de contenido
loading

Tabla de contenido