Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
o
Attach wire support to guide handle with #10 self-dd!l-
in_! screws and #10 fiat washers (Fig° 3). The hose
mlnder should be to the left and gun holder to the d_tht.
Be sure loop of support is pointingupward. Place vinyl
cap onto gun holder.
VINYL CAP
i /
SUPPORT
FIG. 3
WIRE SUPPORT
t
/
FASTENERS
TO ASSEMBLE
REMAINING
COMPONENTS
IMPORTANT:
YOU MUST ASSEMBLE WAND AND AT-
TACH ALL HOSES
BEFORE
YOU START ENGINE,.
STARTING
ENGINE
WITHOUT
ALL HOSES
CON-
NECTED
AND
WATER
SUPPLIED
WILL DAMAGE
PUMP°
Remove cap from top of
pump and insert oil fill
cap included in parts bag
(Fig 4).
Remove male connector to inspect Intake Supply
Screen in water inlet for cleanliness and inspect Inlet
Screen on female connector. Reattach male connector
to water inlet and attach female connector to garden
hose.
o
Unravel high pressure hose, remove protective cap
from end of hose and check that threads are properly
covered with teflon tape° If tape is not properly applied,
reapply it so threads are fully covered. The tape seals
the connection from hose to gun and wand assembly°
.
Attach fitting with teflon tape to gun andwand assembly
(Fig° 6). You may want to spin gun or spin hose to
secure connection. Tighten with adjustable wrench.
FIG. 6
Attach the other end of the high pressure hose to high
pressure fitting on pump (Fig° 7). Tighten with adjust-
able wrench.
DETERGENT PICKUP TUBE
HIGH PRESSURE
HOSE
FIG. 4
Included with this unit is a Quick-Connect
fitting you
attach to Water Inlet on pump. The quick-connect
includes two parts --
a Male Connector factory-in-
sta!led on water inlet and a Female Connector (Fig. 5).
WATER INLET
FEMALE CONNECTOR
MALE CONNECTOR
FIG. 5
FIG. 7
=
Attach Detergent Pickup Tube and Filter as shown in
Fig. 7.
=
To attach the adjustable
nozzle,
refer to Operation
section, Fig. 10o; to store optional turbo nozzle, refer to
Operation section, Fig. 17.
CHECKLIST
*
Check that fasteners you used to install wheels and
handle are tight.
Vibration during operation may
loosen fasteners that are not tight enough.
°
Check for proper hose connections (high pressure and
water supply) and for tight connections and that there
are no kinks, cuts, or damage to the high pressure
hose_
.
Provide proper water supply (not to exceed 140°F)_
,,
Be sure to read "Safety Rules" and "Operation"
sec-
tions before using the pressure washer.
Publicidad
Tabla de contenido
