Würth Master DTS 151 C Instrucciones Para El Manejo página 8

DTS.book Seite 8 Montag, 31. März 2008 11:08 11
Compressed-air excentric grinder
N° of article
Course (mm)
Idle-running speed
Surface quality
Material removal
Grinding disc
External dust collection
Speed regulation
Hose section
Performance
Air pressure, max.
Air consumption
Air connection
Handle
Weight
Machine Elements
1 Compressed-air excentric grinder
2 Compressed-air lubricator*
3 Pressure reducer
4 Filtre/water separator
5 Non-return valve
6 Pressure reducing valve
7 Compressed-air line
8 Compressor
9 Lever On/Off switch
10 Speed regulator
11 Spanner flat
Not all of the accessories illustrated or described are included
as standard delivery.
*The compressed-air tool can, as far as the conditions are ful-
filled, be used without oil.
Intended Use
This tool is designed for dry grinding with mounted dust
collection.
For damage caused by usage other then intended, the
user is responsible.
8
Tool Specifications
DTS 151 C DTS 152 C
0703 751 0 0703 752 0
2.5 mm 5.0 mm
12 000 rpm 12 000 rpm
150 mm 150 mm
10 mm 10 mm
225 W 225 W
6.3 bar 6.3 bar
297 l/min 297 l/min
1/4" 1/4"
— —
0.68 kg 0.68 kg
Compressed-air connection
Provide the tool with clean, dry air. A higher pres-
sure reduces the lifetime of the tool considerably.
The compressed-air tool has been designed to be
used without oil, assuming a clean, dry air supply.
Prior to use, add some drops of oil into the air admis-
sion of the compressed-air tool. As an alternative,
use a compressed-air lubricator in the air conduction
which is set at two drops per minute max.
Pressure that is too low reduces the performance of
the pneumatic tool; pressure that is too high is not
allowed.
Changing the sanding sheet/
Changing the grinding disc
Changing the sanding sheet
Take the sanding sheet off the grinding disc.
If necessary, clean the velcro of the grinding disc and
mount the new sanding sheet.
Changing the grinding disc
Keep the spanner flat 11 at the motor spindle with a flat
spanner and unscrew the grinding disc.
Screw new grinding disc and hold it with flat spanner.
DTS 153
0703 753 0
5.0 mm
12 000 rpm
150 mm
10 mm
225 W
6.3 bar
297 l/min
1/4"
0.9 kg