Worx Landroid M Serie Guia De Instalacion página 14

3. Connect the base to the boundary wire
14
EN
OUT
IN
IN
OUT
3.1
Cut the end of the wire to a length that's appropriate convenient
for reaching the clamps.
Strip the two ends of the wire.
NOTE: Too long redundant wire may cause the signal problem.
3.2
When connecting to the charging base there is an IN wire and
an OUT wire, as shown. Connect the IN-wire to the red clamp
of the charging base and the OUT-wire to the black clamp.
Then close the cover.
NOTE: Please fix the boundary wire around the charging base
firmly with the wire pegs.