Final Recommendations - Telcoma K100 Manual De Instrucciones

GB

FINAL RECOMMENDATIONS

- Installation of the automation device should be accomplished in a workmanlike way by qualified
personnel in accordance with the law and in compliance with directives EN 12453 and EN 12445.
- The installation should be equipped with stops even if limit switches are installed.
- Should the slowdown function be used, the anti-crushing system is cut out during this stage and
the installation should therefore be equipped with protective devices, such as safety edges.
- Should the motor be released manually, before carrying out any opening or closing movement,
reset the control unit (disconnect and reconnect the power supply).
Should this be impossible, the control unit synchronises its movements after 3 openings or clo-
sings.
- Give the end user all the necessary information for correct use of the automation device and warn
of the possible associated risks.
- Keep this instruction booklet to hand for future consultation.
In line with its continual product improvement policy, both in aesthetic and functional terms,
TELCOMA Srl reserves the right to make changes at any time without notice.
DISPOSAL
This product is made up of various components that could contain pollutants. Dispose of properly!
Make enquiries concerning the recycling or disposal of the product, complying with the local laws in
force.
The undersigned Augusto Silvio Brunello
TELCOMA S.r.l. Via L. Manzoni, 11 - Z.I. Campidui - 31015 Conegliano - (TV) Italy
Declares that the product:
Type: Control unit
Is in conformity with the essential requirements of section 3 and relative provisions of the Directive 1999/5/CE, if used for
the purposes for which it has been designed.
Is in conformity with the safety and health requirements, section 3.1.a
Applicable standards: EN 60950
Is in conformity with the protection requirements related to electromagnetic compatibility, section 3.1.b
Applicable standards: EN 301 489-3
Is in conformity with radio frequency input efficiency within the spectrum, section 3.2
Applicable standards: ETSI EN 300 220-3
Place and date:
CE Declaration of Conformity
In accordance with Directive 1999/5/CE (R&TTE)
, Sole Director of the firm:
Model: K100
Conegliano, 12/01/2005
Use:Gate operator control unit
The Sole Director
Augusto Silvio Brunello
35